Post by evalha007 on Feb 15, 2006 1:06:46 GMT -5
I posted something similar to this a few weeks ago. I tested my A-5 today with my new Rampage board. I now have two problems.
A) This is more important: I cannot get my pressure to go below 900 psi, no matter how I adjust my palmer's reg. It works just fine with C02. Could the output pressure on my HPA tank be too high? Could my reg be messed up? I am quite sure the gauge itself is fine.
B) I can fire single shots, or short bursts but as soon as I let loose with 20bps, the marker fires for about 1/2 to 1 second and then burps...not recocking. (Cyclone is feeding just fine btw, thanks to my new QEV) I recock it and can repeat the same process over and over. This was with a full HPA tank, I haven't tried it yet with C02 and the Rampage board.
Thanks!
A) This is more important: I cannot get my pressure to go below 900 psi, no matter how I adjust my palmer's reg. It works just fine with C02. Could the output pressure on my HPA tank be too high? Could my reg be messed up? I am quite sure the gauge itself is fine.
B) I can fire single shots, or short bursts but as soon as I let loose with 20bps, the marker fires for about 1/2 to 1 second and then burps...not recocking. (Cyclone is feeding just fine btw, thanks to my new QEV) I recock it and can repeat the same process over and over. This was with a full HPA tank, I haven't tried it yet with C02 and the Rampage board.
Thanks!
