Custom Mag Well

[SWATORNOT]

Still in the design stages at this point. I am working on redesigning this so that the clip will be removable from the mag well.

This will be made from 1/8" steel plate, or aluminum, which ever I can find scraps of. I will be sure to post some updates of this as it progresses now that i have myself a Digi Camera finally:)

The Mag Well mounts over the tombstone and will require that SpecOps A5-A2 tombstone modification to work as planned.

Right now the Mag Well has been "prototyped" with cardboard. Thankfully because it took 5 tries to get the measurements correct along with a good fit.

I am now working on a new template that brings the slants the rear of the mag well back towards the trigger to allow room for the release mechanism I will use in the removable Mag well design.

**Keep in mind that the clip will be cut down to the right size for this to fit properly. I have not done this yet, so i do not have a photo of the Mag well and clip as one piece on the marker...

[SWATORNOT]

Removable Clip Mag Well Pics are up!
In the second picture you can see how it runs closer to the trigger guard. This is the area where the clip release will be loacted...

[SWATORNOT]

Updated pics of the Mag Well +Clip+ Receivers;

Non-Removable Clip Mag Well;


Removeable Clip Mag Well;




Keep watching

[jester]

I've been working on the same type mount, but for an MP mag. Actionvillage carries a PSI C/A to 1/8 NPT adapter(http://www.actionvillage.com/is-bin/INTERSHOP.enfinity/eCS/Store/en/-/USD/DisplayProductInformation-Start;sid=xyXJURG7puPJtFW99ugJ-Rtv1efATcjxj20=?ProductID=jVysFAY7dywAAAD4hKzkrFs5
) that will allow you to use either a macroline, or braided line. This is the way I was gonna go.
Hope this helps.

[Pyro]

Swatornot: great job! Very nice.

[Snake Eyes 88 USMC]

[wheelchair]

Just saw something similar over on specops, made by UMS -> forum.specialopspaintball.com/index.php?showtopic=46465

Slightly different in that it extends to the front of the marker.