Several questions concerning regs and pressures

[cmw0081]

What pressure does the A5 work best at? I recently switched to HPA. Was using a Palmers Female Stabilizer, but just barely used it before switching over so its not broken in. I also have a RT if that makes a difference in the operational pressure.

How do I sweespot my reg if I don't have a guage to know when I'm at the right pressure? I was considering dropping the Female reg. Well guess I allready decided because I have a DOP vertical adapter coming in the mail. I was planning on using a WGP ERGO reg with that.

I'm planning on switching to an EGRIP very soon, (basically whenever I get off my but and ride to the shop to get one).

Hmmmm...... I think thats it for now, if I got any more questions I know where to come.

[cmw0081]

Anyhelp?

not that I know what pressures I'm gettting out of my female reg lol

[Trigga Nometry]

The A-5 is designed to run best between 800-850psi or there abouts. That is what most CO2 and HP tanks run at.

I used to run my A-5 at about 625psi using a Female Stabilizer. For that I had to use a RVA along with a stronger drive spring to really get the valve to stay open long enough to get to a good velocity.

It is really tough to sweet spot a regulator on an A-5 because there is no real fine tuning that can be done on say higher end paintball guns. That is not to say you cannot find optimum settings. It will be a matter of reg pressure and drive spring tension and finding what combination of the two work best for you.